- 2B / BW Shalimar Bagh, Opp. BQ Market, Near DLF Mall New Delhi - 110088, India.
- :+91-9312-871-070
Manufacturers, Exporters, Suppliers of RO Disinfectant Chemicals
RO Disinfectant Chemicals in Baddi (Non-Oxidizing Microbiocide)
Chlorine is cheap, but it is also the fastest way to kill a Polyamide membrane. Once the oxidised layer forms, rejection efficiency drops and there is no way to reverse it. Baddi plants in the Baddi-Barotiwala-Nalagarh industrial belt cannot afford that risk, especially pharmaceutical units in Chikniwala and Kalyanpur where every litre of process water has to be validated for microbial safety. Innova Corporate (India) supplies a Non-Oxidizing RO Disinfectant in Baddi that delivers the same microbial kill as chlorine without any of the membrane damage. It is safe for Polyamide and TFC membranes, potable water compliant, and trusted by pharma, food and beverage units across the region.
The formulation works by disrupting microbial cell walls and preventing the re-establishment of biofilm on the membrane surface. Because it is non-oxidizing, it does not attack the membrane polymer itself, and it leaves no chlorinated by-products behind in the reject stream — a critical requirement for food processing lines around Barotiwala and Nalagarh where taste and odour of the product water matter. Dosage depends on the biological load at your Baddi site, and the same product supports both continuous preventative dosing and shock disinfection during scheduled shutdowns.
Key Features & Strategic Benefits for Baddi:
- Broad-Spectrum Efficacy: Highly effective against a wide range of microorganisms, preventing bio-fouling and the pressure drops that follow in Baddi's high-load pharmaceutical and food processing RO systems.
- Potable Water Safe: Certified safe for use in RO systems producing drinking water for Baddi and the wider BBNDA belt, when dosed as per guidelines.
- Non-Oxidizing Formula: Unlike chlorine, it does not oxidise or degrade Polyamide or TFC membranes, so rejection efficiency stays stable over the long term.
- Eco-Friendly & Biodegradable: Breaks down safely after use and meets the discharge norms set by the Himachal Pradesh State Pollution Control Board for industrial units in the Baddi region.
- Total System Compatibility: Fully compatible with all RO membrane components, housings and high-pressure pumps used in Baddi plants, with no effect on seals or O-rings.
Application & Dosage for Baddi Plants:
Dosage depends on the severity of biological fouling. We recommend two primary methods for Baddi facilities:
- Shock Dosing (Immediate Disinfection): Use a concentration of 5-10% v/v for rapid system sterilisation during shutdowns or after a bio-fouling event.
- Continuous Dosing (Preventative): Maintain a concentration of 2.5 ppm on the feed water for round-the-clock microbial control and to prevent biofilm re-establishment.
Recommended Membrane Cleaning Protocol for Baddi:
- Disinfect the system with Innova RO Disinfectant.
- Flush thoroughly with permeate water.
- Circulate a High pH Membrane Cleaner solution for 30 minutes, then soak for 1-2 hours.
- Final flush with permeate water before returning the Baddi plant to normal service.
*Note: In multi-pass systems, clean each pass individually for the best results. Replace cleaning solutions if they become excessively turbid.*
Safety & Handling: Proper PPE (splash goggles, lab coats, gloves and vapor respirators) must be worn. Store in original containers in a cool, dry place at your Baddi site, away from direct heat or sunlight.