- 2B / BW Shalimar Bagh, Opp. BQ Market, Near DLF Mall New Delhi - 110088, India.
- :+91-9312-871-070
Manufacturers, Exporters, Suppliers of RO Antiscalant High pH
RO Antiscalant High pH in Gurugram (Super-Threshold Formula)
Gurugram RO plants face a specific kind of water challenge that most generic antiscalants are not designed for. Feed water from borewells across IMT Manesar, Udyog Vihar and the Pataudi Road belt carries high levels of alkalinity, elevated LSI, iron from corrosion of old supply lines, and moderate silica — all at once. Standard acid-dosing programs handle this by dropping the pH, but that adds handling risk and complexity. Innova Corporate (India) supplies a High pH RO Antiscalant in Gurugram that works the opposite way — stabilizing supersaturated salts at alkaline pH, so no acid dosing is needed and the plant runs safer and simpler.
This super-threshold membrane stabilizer prevents precipitation of carbonate, sulfate and fluoride salts directly at the membrane surface. It is engineered for Gurugram feed water with LSI up to +2.6, silica up to 166 ppm, and iron up to 1.2 ppm in reject — the exact operating envelope that plants in Sohna Road, Sector 34 and the old industrial pockets around Udyog Vihar actually face. The formulation is fully organic, biodegradable and compatible with all major membrane brands used in the region.
Key Features & Strategic Benefits in Gurugram:
- Advanced Scale Inhibition: Controls Calcium Carbonate, Sulfates (Barium, Strontium, Magnesium), and Calcium Fluoride across a wide concentration range.
- Dual Action: Works as both a powerful scale inhibitor and an Alkalinity Builder for Gurugram RO systems, replacing the separate pH-correction step.
- Superior Iron Sequestration: Delivers excellent control over iron fouling, which is common in Gurugram's older borewell networks and mixed municipal-industrial feed water.
- Eco-Friendly Chemistry: Fully organic and biodegradable, keeping the discharge stream compliant with Haryana State Pollution Control Board norms.
- Cost-Efficiency: Low chemical dosage requirement supports higher recovery and fewer cleaning cycles for local plants.
- Wide Compatibility: Compatible with all major membrane brands and INNOVA series coagulants and flocculants.
Dosage & Application Guidelines for Gurugram:
Dose the antiscalant directly into the RO feed water tank or line (post-pretreatment). Typical dosing ranges from 1 ppm to 15 ppm, depending on the following parameters at your Gurugram facility:
- Standard Conditions: 1-5 ppm for moderate hardness and TDS.
- High Iron (0.5 - 1.0 ppm): Increase dosage by 10-15 ppm to stabilize calcium and iron effectively, especially for IMT Manesar and Pataudi Road borewell water.
- Silica Management: At 10-15 ppm, the formula can fully inhibit silica up to 166 ppm, which covers most Gurugram feed water conditions.
Storage & Safety: Store in original, tightly sealed containers in a cool, dry place at your Gurugram site. Keep away from direct heat and sunlight. For precise dosing calculations based on your water analysis, refer to the Technical Data Sheet (TDS) or contact our experts specializing in Gurugram water treatment.